5/2/2024 0 Comments 8' wood scaffold plankthick plywood deck and reinforced to evenly distribute the load. Respectively, the 7-foot (AP-7), can handle seventy-five pounds per square foot, while the 10-foot can handle fifty pounds per square foot. The Build Frames Aluminum and Plywood Scaffold Platform is built with a rugged 5/8 in. Like the all-aluminum scaffold plank, the aluminum plank with plywood top comes in the 7-foot and 10-foot options. Be indelibly and permanently marked by painting or stencilling as no longer suitable for use as a scaffold plank. Build Frames Aluminum/Wood 0.29-ft H x 7-ft L 250-lb.Have labelling on both sides planed off.HyPLANK used for any other purpose (or subject to trauma) should: Use for any other purpose voids continued use as a scaffold planking. for the support of persons, equipment, and materials on scaffold constructed and loaded in accordance with AS1576 and AS1577. Our Southern Yellow Pine OSHA scaffolding planks are sourced right here in the southeast United States. HyPLANK scaffold planks are only intended for use as scaffold planks, i.e. HyPLANK at the time of dispatch from the manufacturing site has a moisture content of between 8-15%. Carter Holt Harvey LVL ensures that its wood is legally sourced from managed forests and offer FSC ‘Chain of Custody’ certified upon request. HyPLANK is manufactured using an ‘A’ Bond with less than 0.5mg/l Formaldehyde (equivalent to E0) emissions from the final product.įor quality assurance the hyPLANK range is manufactured with independent audit processes and product certification. HyPLANK is manufactured in accordance with AS/NZS 4357-2005, Structural laminated veneer lumber and designed to be used as a non-modular scaffold plank as a part of a working platform in accordance with the requirements of AS/NZS 1576.1 and AS/NZS 1577. Individually proof tested for safety and performance.Each board measures 2.4 metres in length, and is 225mm wide. These boards have banding on each end which is an added measure to help prevent the wood splitting under tough site conditions. EWPAA certified with quality control procedures Extra strong scaffolding planks which measure 63mm thick.OSHA requires 6 but many contractors opt for 12. Each stick is branded for ease of identification The only difference is how much lap you feel comfortable with.on October 10, outside of Fries Gagarge on Cockrell Road. Police said the theft occurred between 12:00 p.m. 22 in wide wood deck, available in 6 ft, 8 ft, and 10 ft lengths. Sourced from managed plantation forests – Available Forest Stewardship Council ® (FSC ®) certified (FSC ® C007103) upon request P22W series scaffold planks for use on narrow span and wide span aluminum scaffolding.Paper wrapping and custom embossing also available. Available in S4S or rough surface finishes. Precision trimmed ends with clipped corners, painted and rodded. Wax emulsion end seal reduces moisture ingress OSHA planks apparently are 2' x 10' x 8 Southern Yellow Pine and cost about 30-40. The features of our scaffold planks include: Solid sawn wood planks graded 2200F MSR 1.8E.The defined structural properties of LVL and quality control processes ensure a plank that can be used in accordance with AS/NZS 1576.1:2010 and AS/NZS 1577:2013. HyPLANK ® is a strong lightweight LVL scaffold plank.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |